Ignitor Switches - LG LRG30855S Series Training Manual

IGNITOR SWITCHES

The ignitor switches are located inside the manifold panel and are attached to
each maintop burner valve. The back of each switch is molded to conform to the
front of the burner valve and is locked in place by 2 tabs. All switches are wired
to a single harness and can be replaced separately.
Note! To replace the ignitor switch for the left or right rear burner, it is
necessary to remove the left or right rear burner valve from the gas
manifold.
Caution! The 2 lock tabs on each ignitor switch are fragile. Tab breakage
can occur if excessive release pressure is applied.
When replacing the ignitor switch for the left or right rear burner, remove the
valve from the gas manifold.
NOTE! When replacing an ignitor switch, cut the switch wires and splice
the new switch using approved connectors and heat shrink tubing.
GAS RANGE
1. Be sure the range is unplugged.
2. Remove the manifold panel.
(See page 39.)
3. Remove the protective cover
from the valve stem.
4. Using a small flat blade screw-
driver, carefully pry on the two
release tabs and slide the switch
off the valve stem.
Page 40 of 72 TRAINING MANUAL