Table of Contents
Advertisement
DOOR
The doors can be separated into two assemblies: (1) the outer assembly,
consisting of the handle, vent trim, outer glass, and frame; and (2) the inner
assembly, consisting of the inner panel, gasket, glass panels, and insulation. The
inner and outer assemblies are held together by two T-20 Torx
corners and four ¼" hex head screws across the bottom edge.
The gasket is held in place between the inner and outer sections of the inner
door panel.
NOTE!
When replacing the gasket, be sure the gasket bead is positioned evenly and
uniformly between the outer and inner sections of the inner door panel.
GAS RANGE
1.
Remove the oven door. (Page 18.)
2.
Place the door inside up on a
padded surface.
3.
Remove the two Torx T-20
from the top corners of the inner
panel. Remove the four ¼" hex
head screws from the bottom of the
door and remove the inner
assembly.
4.
Place the inner assembly inside up
on a padded surface.
5.
Remove the four ¼" hex head
screws, the inner door panel, and
the insulation.
6.
Remove the four ¼" hex head
screws from the outer frame and
carefully lift off the outer frame.
Page 23 of 72
®
screws in the top
®
screws
TRAINING MANUAL
Advertisement
Table of Contents
