Electronic Range Control (Erc); Control Panel And Touch Board - LG LRG30855S Series Training Manual

ELECTRONIC RANGE CONTROL (ERC)

To access the electronic range control (ERC or main board), put the control
panel into the service position. Remove the four Phillips screws (two on each
side). Mark and label the wire locations before disconnecting the ERC.

CONTROL PANEL AND TOUCH BOARD

The control panel and touch board are supplied as an assembly. If the touch
board is damaged, the entire control assembly must be replaced.
To replace the control panel and touch board, put the control panel into service
position. The ERC must be removed and the wiring harness must be
disconnected from the touch board before it can be removed.
GAS RANGE
1. Wire tie holding wire harness to ERC.
2. Ground wire to ERC board.
3. Wiring harness to touch panel.
Page 35 of 72 TRAINING MANUAL