Removing/Assembling Oven Door Handle; Before Removing/Assembling The Oven Door Handle; Removing Oven Door Handle; Assembling Oven Door Handle - LG LSES6338N Owner's Manual

en-us_main.book.book Page 22 Tuesday, July 18, 2023 6:28 PM
22 INSTALLATION
and off periodically even when the knob is in
the Hi position. This cycling prevents the
glass-ceramic from being cracked by thermal
shock.
NOTE
• The Warm Zone does not consume enough
power to glow red.
4
After checking all the surface heating
elements, check the locking system by
pressing Control Lock for three seconds. The
oven controller should lock and the cooktop
should not operate while the Control Lock
function is turned on. Pressing Control Lock
for three seconds to disable Control Lock.
5
Now check the oven's operation. Turn the
oven mode knob to select the Bake mode.
350 °F appears in the display. Press START.
6
The oven should finish preheating in 15
minutes, and the convection fan should
operate while the oven is preheating.
7
After checking the oven's operation, turn the
temperature up to 450 °F and leave the oven
on for at least an hour to help remove any oil
which might cause smoke and odors when
first using the oven.
NOTE
• Smoke may come out of the range when it is first
used.
Removing/Assembling Oven
Door Handle
Before Removing/Assembling the
Oven Door Handle
• Tools Needed
- 3/32" Allen wrenches
CAUTION
• When assembling or disassembling the handles,
grasp the handle firmly to avoid dropping it.
• When assembling or disassembling the handles,
wear gloves for your safety.
• We suggest you have another person hold the
handle in place while you remove/insert the
screws.
• Do not swing the handle into nearby people or
animals.
• Make sure that the set screws are in place and
the pockets at the ends of the handles are
aligned correctly over the mounting fasteners on
the doors. The set screws should be loose
enough to allow the pockets to slide down into
place over the mounting fasteners on the door.
• Make sure that there is not a gap between the
door and handle after assembling the handle.
• After assembling the handle, pull the door open
to make sure the screws are fully assembled.

Removing Oven Door Handle

1
Loosen the set screws
side of the handle with a 3/32 in. Allen wrench
and remove the handle.

Assembling Oven Door Handle

1
Place the handle on the door by fitting the
handle footprints over the mounting
fasteners and tightening the set screws
with a 3/32 in Allen wrench.
located on the lower
a
a