Stick Mode Switch & Stick Calibration - Walkera ZHUN Quick Start Manual

Walkera All Rights Reserved
17.3 Stick Mode Switch & Stick Calibration
Factory setting of remote control stick mode & stick calibration has been determined; please refer to
the following operation method for switching and calibration.
Be sure to switch off the aircraft power or lock motor before operation.
Stick Mode Switch
1. Long press "
Enter stick
Mode
switch
2. Short press "
Exit stick
3. Long press "
Mode
switch
Japanese hand (right hand throttle)
Japanese hand
Elevator
Rudder Aileron
※ Customization also supported in APP.
Stick / thumbwheel calibration
Long press "
Operate the stick /thumbwheel several times within mechanical tuning range and then back in the middle.
Long press the "
calibration.
When you exit if vibrate alert, then the calibration fails, please recalibrate.
" 3~5 sec
"
" 3~5 sec
American hand (left hand throttle)
Throttle
Rudder
" button for 3 to 5 seconds, four lights flash alternately to enter stick / thumbwheel calibration.
" button for 3 to 5 seconds again, four indicator lights turn on, then exit stick /thumbwheel
When power indicate lights off, enter the stick mode switch.
Choose Japanese hand (right hand throttle),
American hand (left hand throttle).
When power indicate lights up, exit the stick mode switch.
American hand
Throttle Elevator
Aileron
ZHUN
Quick Start Guide
power indicate lights
match the stick mode
10
Japanese hand American hand
25
23