Binding; Function Setting; Model Select; Reverse Setting - Walkera W100S User Handbook Manual

Qr series
Table of Contents

Advertisement

Touch Ell in flight control interface to enter to setting menu, show as below:
Apple setting interface
Reverse
Model select—.
I
Mode Switch
Vibrate key
Reset
Mode select—.
AUX Trim
to
• •
Channel Select —.
Switch(4ch & 6ch)
Reset
Reverse setting
10
MTC-01
control
I
05111314NO
• Rudder •
• Aileron •
2.LIG
Hz
10.3.3 Binding
Plug the MTC-01 to the audio jack of phone, and turn on the MTC-01, the data transfer indicator is off after short
green flashing, and the power indicator keeps blue light. Press Binding Icon in the flight control interface.The
binding indicator is flashing in blue light(If the blue light don't flash, please press the Binding Reset Key in the
flight control interface and then press the binding key until the binding indicator blue light flashes). Connect the
UFO battery, the light becomes RED and flashing. The indicator of the UFO becomes solid after successful
binding, At this point, the binding could be finished with touching any stick of radio(The throttle stick is excluded),
or you can wait until the automatic binding by the phone(Longer time is needed). The data transfer Green light
flashes, the power BLUE indicator keeps solid. The RED indicator of UFO becomes solid after flashing(the receiver
programe is initialization ), the binding is successful .
10.4 Function setting
10.4.1 Model select: there are 4 model can be selected.
10.4.2 Reverse setting:The settings of elevator, aileron, throttle, rudder, gyro, pitch,etc are normal. If not select
as normal, select as reverse.
10.4.3 Vibration switch: If vibration switch turn on (not select as normal but turn on), when operate the control
ball during the flight, the phone will vibrate.
10.4.4 AUX trims: touch + or - to change the value according to quadcopter performance.
10.4.5 Channel Select: gyro sensitivity setting, touch + or — can change the values.
10.4.6 Mode switch
There are four switch modes. Right hand throttle (Mode 1, Mode
3);
Left hand throttle (Mode 2, Mode 4).
Mode I (Right hand throttle)
Mode 2(Left hand throttle)
Mode 3(Right hand throttle)
Mode 4(Left hand throttle)
20

Advertisement

Table of Contents
loading

Table of Contents