Check Battery Levels - Walkera ZHUN Quick Start Manual

Walkera All Rights Reserved
4.3 Installation of fire extinguishing tank and dry powder conveying pipe
1
Hang the fire extinguishing tank in
place on the holder and tighten the
hand tightening screw.
4
First unscrew the protective plugs
at the fire extinguisher tank and the
dry powder conveying pipe joints,
and then screw the protective plugs
together for store.

5.0 Check Battery Levels

Turn on the remote controller and intelligent flight Battery to check the battery level.
Be sure the battery was fully charged at the first use.
1) Long press the power button for 2~3 seconds to turn on the remote controller.
2) Press the flight battery level detection switch to turn on the battery indicator (green light is on).
(Repeat this operation to turn off the flight battery level indicator)
Low High
2
Connect the fire extinguishing tank
power cord.
5
Check if the gasket in the dry
powder conveying pipe joint
nut is detached. If it has fallen
off, put it back in the nut.
Fig.5.0-1
ZHUN
3
Install the dry powder conveying
pipe to the dry powder conveying
pipe holder on the aircraft' s tripod
and fix it with hand-tightening the
screw.
6
Screw thedry powder conveying
pipe joint nut into the fire extinguisher
tank joint in the direction of the red
arrow until it is tight.
Low
Fig.5.0-2
Quick Start Guide
High
9