Charge The Batteries - Walkera ZHUN Quick Start Manual

ZHUN
Quick Start Guide

6.0 Charge the Batteries

6.1 Remote control charging
Tip: The device is equipped with a lithium battery of 7.4V
6000mAh, which is available DC 12 to 15V for charging.
1) Connect the charger to the AC power (100 ~ 240v 50/60hz).
2) Only use the walkera charger for your remote controller.
Please turn off the remote controller before charging.
3) The charging indicator of remote controller turns green means remote controller charging finished completely.
6.2 Aircraft battery charging
Steps
1) Power on: Connect the AC power, turn on the power switch, the charger will "click", the fan will rotate once, and
the LCD will display the following interface.
Battery type (lithium battery /
high voltage lithium battery)
Charging current (1.0-20.0 A)
2) Connect the battery: Please connect the battery and charger according to the connection as shown below, as
shown below:
(Note: The number of lithium battery packs that support charging is 12 knots; the battery charging cable and
the balance port must be connected to the charger at the same time.)
Connect the balance charging cable as shown in red arrow.
Connect the battery charging cable as shown by the blue arrow (Choose any red and black cable).
3) To start charging: Press 3) To start charging: Press 3) To start charging: Press 3) To start charging: Press
Press and hold the button Press and hold the button Press and hold the button Press and hold the button
/
STOP
Fig.6.2-3
10
FAST CHARGE
LiPo
20.0A Stand-alone
Fig.6.2-1
and and and and at the same time for 5 seconds until the battery type is LiHv on the screen, at the same time for 5 seconds until the battery type is LiHv on the screen, at the same time for 5 seconds until the battery type is LiHv on the screen, at the same time for 5 seconds until the battery type is LiHv on the screen,
for 2 seconds and then press the button for 2 seconds and then press the button for 2 seconds and then press the button for 2 seconds and then press the button
/
STATUS START
Charging port
Charging mode (fast charging, precise charging, battery storage)
Synchronization status (single, master, slave)
Fig.6.2-2 Fig.6.2-2
LiPo
FAST CHARGE
Stand-alone
20 .0 A
Fig.6.0
to confirm charging. to confirm charging. to confirm charging. to confirm charging.
LiHV FAST CHARGE
Stand-alone
20 .0 A
Fig.6.2-4
Walkera All Rights Reserved
Power Adapter