Table of Contents
Advertisement
Walkera All Rights Reserved
16.2 Compass Calibration
If there is circles or drift in flying, please calibrate the compass.(the motor must be locked and the
red and blue LED lights turn off )
Please calibration outdoors and far away from strong electromagnetic interference.
The compass calibration steps are as follows:
1). Place right/left sticks at lowest location, toggle
them inward and keep for 5 seconds until the
aircraft's red LED lights flash quickly .
2). Horizontal 360°rotation of aircraft until red LED
lights turn off and blue LED lights flash quickly.
3). Vertical 360° rotation of aircraft (heading down)
until green LED lights turn off, indicating successful
calibration, and place aircraft at a horizontal location.
In case of failure to calibrate, please follow
above procedure to repeat calibration.
16.3 Stick Mode Switch & Stick Calibration
The remote control rocker mode and joystick calibration have been set at the factory; please refer to
the following operation method for switching and calibration.
Be sure to switch off the aircraft power or lock motor before operation.
Stick Mode Switch
1. Click the "
" icon on the WKDrone-ZHUN interface,
then click "
" to enter the remote control settings
interface.
Stick and gimbal dial calibration
Long press "
" button for 3 to 5 seconds, four lights flash alternately to enter stick / thumbwheel calibration.
Spray
Operate the stick /thumbwheel several times within mechanical tuning range and then back in the middle.
Long press the "
Spray
calibration.
When you exit if vibrate alert, then the calibration fails, please recalibrate.
" button for 3 to 5 seconds again, four indicator lights turn on, then exit stick /thumbwheel
Keep for 5 seconds
Ground
heading
2. Click on "Stick Mode" to enter the stick sode option
and select the mode you want.
ZHUN
Quick Start Guide
Tail toward operator
23
Advertisement
Table of Contents
