Table of Contents
Advertisement
Walkera All Rights Reserved
15.2 Spraying dry powder fire extinguishing
5.00m
5.00m
14
15
5
m
3
4
1
When the aircraft flies to the target
window or 5 meters in front of the
doorway, the aircraft will automatically
stop moving forward, at which point you
can manipulate the direction rocker to
aim at the target.
16.0 End flight
1). Manual Landing, AUTO Landing or Return to Home function landing or low voltage landing.
2). First remove the head cover and then disconnect the aircraft from the power supply (unplug the power plug),
then turn off the power of the remote controller.
3). Finally,release the battery strap and remove the flying battery from the aircraft.
17.0 Additional remarks
17.1 Compass Calibration
If there is circles or drift in flying, please calibrate the compass.(the motor must be locked and the
red and blue LED lights turn off )
Please calibration outdoors and far away from strong electromagnetic interference.
The compass calibration steps are as follows:
1). Place right/left sticks at lowest location, toggle
them inward and keep for 5 seconds until the
aircraft's red LED lights flash quickly .
2). Horizontal 360°rotation of aircraft until red LED
lights turn off and blue LED lights flash quickly.
3). Vertical 360° rotation of aircraft (heading down)
until green LED lights turn off, indicating successful
calibration, and place aircraft at a horizontal location.
In case of failure to calibrate, please follow
above procedure to repeat calibration.
5.00m
5.00m
14
15
5
m
3
4
2
After aiming at the target, slide the
automatic obstacle avoidance switch to
the closed position in the APP interface.
Ground
ZHUN
3
Double-click the "
the spraying dry powder. the status
indicator of fire extinguisher status will
red light after the fire has been successfully
extinguished, double-click the "
again to turn off the spraying.
Keep for 5 seconds
heading
Quick Start Guide
Common
" button to turn on
" button
Tail toward operator
21
Advertisement
Table of Contents
