Table of Contents
Advertisement
Starlight QUICK START GUIDE
14.3 Compass Calibration
If there is circles or drift in flying, please calibrate the compass.(the motor must be locked)
Please calibration outdoors and far away from strong electromagnetic interference.
The compass calibration steps are as follows:
Keep for 5 seconds
Place right/left sticks at lowest location,
toggle them inward and keep for 5 seconds
until the aircraft's red LED lights flash quickly .
In case of failure to calibrate, please follow above procedure to repeat calibration.
14.4 Stick Mode Switch & Stick Calibration
Factory setting of remote controller stick mode & stick calibration has been determined;
please refer to the following operation method for switching and calibration.
Be sure to switch off the aircraft power or lock motor before operation.
Stick Mode Switch
1)Click the "
" icon on the APP interface, then click
"
" to enter the remote controlLER settings interface.
Stick / thumbwheel calibration
Long press "
" button for 3 to 5 seconds, four lights flash
alternately to enter stick / thumbwheel calibration.
Operate the stick /thumbwheel several times within mechanical
tuning range and then back in the middle.
Long press the "
four indicator lights turn on, then exit stick /thumbwheel calibration.
When you exit if vibrate alert, then the calibration fails,
please recalibrate.
18
Ground
Turn the aircraft's nose up and the
aircraft rotates 720° along the vertical
axis.
" button for 3 to 5 seconds again,
Heading
2)Click on "Stick Mode" to enter the stick mode option
and select the mode you want.
Long press this button to
enter the stick/thumbwheel calibration
Walkera All Rights Reserved
Keeping the aircraft on the same
horizontal and rotate 720° along the
vertical axis, then placing the aircraft
on the horizontal ground.
Advertisement
Table of Contents
