Installation Of The Rocket Propulsion Dry Powder Fire Extinguisher; Unfolding Dry Powder Conveying Pipe; Fire Fighting Operation; Use The Rocket Propulsion Dry Powder Fire Extinguisher Extinguishing - Walkera ZHUN Quick Start Manual

Hide thumbs Also See for ZHUN:
Table of Contents

Advertisement

ZHUN
Quick Start Guide

14.2 Installation of the rocket propulsion dry powder fire extinguisher

Install the fire extinguisher in the state where the fire extinguisher status
indicator is off to avoid danger.
First make sure the fire extinguisher
indicator is off and then loosen the
limit screw.

14.3 Unfolding Dry powder conveying pipe

Rotate the nozzle counterclockwise and extend the nozzle forward to fully extend it (after the fire suppression
operation is completed, close the nozzle and screw the nozzle clockwise).
Unscrew nozzle

15.0 Fire fighting operation

Before the operation, it is recommended to adjust the elevation angle of the launch tube to 4.5°,
and set the automatic obstacle avoidance safety distance in the APP to 5 meters to hit the
target more accurately.
Before the operation, slide the automatic obstacle avoidance switch to the open position;
the flight mode must be switched to the GPS mode.

15.1 Use the rocket propulsion dry powder fire extinguisher extinguishing

5.00m
5.00m
14
15
5
m
3
4
1
When the aircraft flies to the target window
or 5 meters in front of the doorway, the
aircraft will automatically stop moving
forward, at which point you can manipulate
the direction rocker to aim at the target.
20
Insert the fire extinguisher from the rear
of the launch tube and turn the fire
extinguisher bullet to align the buckle
at the end with the buckle at the end of
the launch tube.
Fig.14.3
5.00m
5.00m
14
15
5
m
3
4
2
After aiming at the target, slide the
automatic obstacle avoidance switch to
the closed position in the APP interface.
Push the fire extinguisher forward into
place, then turn the fire extinguisher
clockwise until it stops rotating and
tighten the limit screw.
Pull the Dry powder conveying pipe
forward so that it is fully extended
3
Double-click the "
status indicator of fire extinguisher status
will red light.the fire extinguisher will fly
to the target,after 5 seconds of reaching
the target room, the dry powder will be
automatically sprayed to extinguish the fire.
Walkera All Rights Reserved
Common
" button and the

Advertisement

Table of Contents
loading

Table of Contents