Note the L-shaped side tabs on the top cover that t through the system
board and into the bottom cover on each side. Moving the RFI cover back
also disengages these tabs.
10. Raise the back end of the RFI cover and remove the cover.
11. Remove a RAM card from the static-free packing material.
installed in pairs, using either the front pair or the rear pair of RAM
connectors on the board computer. Note that the RAM card is notched on
one end to t the keyed connector.
Figure A-3. Installation of Two RAM Cards
12. Place the rst card vertically in the available position farthest from the
front panel, and align the edge notches with the connector.
Cards are
Installing Additional Memory
A
A-7