HP 9000 700 Series Owner's Manual page 133

Once the secure boot mode is activated, the only way to
Caution
deactivate it is to use the Rst/Abt switch, as in the previous
section \Setting the Console Display Format" in this Appendix.
This procedure is outlined below:
1. Make sure the VXIbus mainframe power is
console is connected and turned
2. Hold the Rst/Abt switch on the panel in its \
position.
3. Turn
4. Release the Rst/Abt switch.
5. You will begin seeing a set of messages on your screen,
some of which will display clearly and some of which will
not. The messages repeat the same content and each will
remain on your display for about seven seconds. Select
the console format, using
the screen instructions, as in \Setting the Console Display
Format".
6. You will then see the boot console handler
7. Type
menu.
8. Type
9. At the
secure boot mode from
10. Type
11. Type
on the VXIbus mainframe power.
4 ESC 5
. You will see the
3
4 Enter 5
. You will see the
5
4 Enter 5
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN menu, type
CONTROL FLAGS
NNNNNNNNNNN
YES
to return to the
0
4 Enter 5
to reset the system.
77
Using the Boot Console Handler
o and the
on .
" (down)
Abt
or a number, according the
NNNNNNNNNNNNNNNNNNNNNNNNNNNNN
MAIN MENU
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
MODE CONFIGURATION
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN menu.
CONTROL FLAGS
to change the
2
4 Enter 5
to NNNNNNNN .
NO
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
MODE CONFIGURATION
B
.
menu.
B-17