Table of Contents
Advertisement
Setting the Console Path
If you are using a graphics display or if you are changing from graphics to a
RS-232C display mode, you will need to set the Console Path.
1. Press
at the prompt \
4 ESC 5
2. From the
NNNNNNNNNNNNNNNNNNNNNNNNNNNNN
MAIN MENU
. Type
3
4 Enter 5
4 Enter 5
Path menu. A menu similar to the following appears:
==== CONSOLE PATH ============================
CONSOLE PATH is now [ GRAPHICS 1 ]
Key Device Path
--- -----------------------------------------
1 GRAPHICS 1
2 RS-232 (A)
3 RS-232 (B)
... .........................................
0 Previous Menu
66 Rescan for Console devices
77 Reset the System
----------------------------------------------
To set the CONSOLE PATH, Press Key, then press [Enter/Return]
3. Type
to select the RS-232C Port A as the console path. This will
2
4 Enter 5
give you a menu for selecting the display format for the display mode you
have chosen.
Setting the Console Display Format
If you disconnect or change your graphics display output hardware, it is
possible that the display format may not be con gured properly. In this
case you will need to be familiar with the following procedure to restore the
con guration information relative to the current monitor or console.
the RS-232C setting should always be 9600 baud. Changing this setting may
cause the terminal to display incorrectly.
1. Make sure the VXIbus mainframe power is o and the console is connected
and turned on.
2. Hold the Rst/Abt switch on the panel in its \
System Search started
, access the Path Con guration screen by typing
at the Path Con guration menu to select the Console
Using the Boot Console Handler
. . . "
Note that
" (down) position.
Abt
B
2
B-5
Advertisement
Table of Contents
