Data Transfer Verification; Gsm Modem Status "Stm; Connection Configuration Status "Stcon - Honeywell Elster EK280 Applications Manual

EK280

6.5 Data transfer verification

Prior to the actual data transfer, a communication link to the target must be established.
You can program eight separate connections. For each of the eight connections it must be specified,
- when the data transfers should be executed (i.e. daily within a time window) and
- via which interface the EK280 is to transfer the data (i.e. via the internal modem or via a modem
connected to the terminals).
In order to check the connections' configurations, relevant status information can be retrieved on the "Admin"
and "Serv." tabs of the EK280 under the following path:
Interfaces > internal modem
Interfaces > Terminal interfaces >
Interfaces > Connections
Interfaces > Connections
Interfaces > Connections

6.5.1 GSM modem status "StM"

This value displays the network on which the GSM modem is registered.
It is located on the EK280 "Admin" and "Serv." display tabs under the following paths:
For the EK280 internal modem:
Interfaces > internal modem
For a terminal-connected modem:
Interfaces > Terminal interface
Display Description
Logged out The GSM modem is not currently registered.
If the modem should be registered and "Logged out" is displayed, please check whether
a SIM card is inserted and where necessary a SIM PIN has been entered.
Own network The modem is registered to its own network.
Searching... The modem is currently registering to a network.
Denied Modem registration is denied.
Third party The modem is registered to a foreign network ("roaming").
no command The modem command for reading the modem status is undefined. If this text is
displayed, the EK280 is not correctly parameterized.

6.5.2 Connection configuration status "StCon"

Display Description
0 Establishment of a connection has not yet started.
2 The interface is activated specifically for the connection.
3 The interface to be used for the connection (i.e. the modem) is busy, the EK280 will wait until
connection can be established.
Either the interface has just been used for another connection or the EK280 is waiting to try
again after a failed connection attempt.
This state may persist for several minutes.
4 The interface (i.e. the modem) is ready to establish a connection (i.e. the call time window is
open).
Application Manual
> GSM and GPRS >
GSM and GPRS >
> Connection 1 >
> Connection 2 >
etc.
> Connection 8 >
> GSM and GPRS >
> GSM and GPRS >
StM
StM
StCon
StCon
StCon
StM
StM
61