Honeywell Elster EK280 Applications Manual page 52

EK280
b) Send parameter file
Send the "EK280_2v1.. - FE260 & i-modul Modem 144
chapter 3.66 "Send parameter
For the following customized settings and tests required, press "Navigation" on the left-hand side and
then "Parameterize
i
All the values listed in enSuite under "Parameter" can be found on the "Serv." display tab of the
EK280 under the same path.
c) Setting time window for potential data queries
In the base configuration now displayed you can define time windows, during which data can be cyclically
retrieved from the EK280 via this interface. Time windows 5 and 6 are reserved for EK280 operation with an
FE260, and generally only time window 5 is used. Redundant time windows can be deactivated by setting
the time window start and end to the same value.
In the top of the device window open the path "Parameter" > "Interfaces" by clicking on the relevant
plus signs, and then select
For call window 5 set the start to "00:00" and the end to "23:59" and then select the
to device" icon at the top of the enSuite window.
Wait for around a minute for the EK280 to detect the FE260.
Press the "Transfer changes to
6.3.8.3 Retrieving data with enSuite
If the communication link to the EK280 is via the optical interface, press the "Disconnect" or the
"Disconnect from all
EK280 and then wait for the "o" on the EK280 display to stop flashing.
Set up the TCP-IP communication link from enSuite to the EK280 via "direct connection" (see chapter
3.4 "Setting up a direct communication link to
Once the communication link is set up, you can carry out checks, for instance view certain parameters.
To do this press "Navigation" on the left-hand side of the enSuite window and then
online" in the bottom of the navigation window, then click on the plus sign next to "Parameter" and
then its subsections.
In enSuite press the "Disconnect" symbol or
10
The * asterisk represents the lower-case letter, used to identify the file version, i.e. "a"
Application Manual
file", page 10)
online" at the bottom of the navigation window.
"Call time windows".
device" icon at the top of the enSuite window.
devices" icon to terminate the communication link between enSuite and the
"Disconnect from all
(Analogmodem)_*.WPP"
EK280", page 10).
devices" to end the test retrieval.
50
10
to the EK280. (see
"Transfer changes
"Parameterize