Honeywell Elster EK280 Applications Manual page 64
Hide thumbs
Also See for Elster EK280:
- Operating instructions manual (110 pages) ,
- Applications manual (223 pages)
Table of Contents
Advertisement
EK280
Display Description
5
The interface is released specifically for the connection.
6
The interface (i.e. the modem) is released from other connections for use. (i.e. when the time
window is no longer open)
7
Data transfer via DLMS protocol is in progress.
8
Data transfer via DLMS protocol is complete.
9
Data transfer via Modbus protocol is in progress.
10
Data transfer via Modbus protocol is complete.
11
Data transfer via LIS200 protocol is in progress.
12
Data transfer via LIS200 protocol is complete.
13
The EK280 is synchronizing with the EIServer, in readiness to begin data transfer via DLMS
protocol.
14
EIServer synchronization is complete.
29
No valid recipient specified.
30
A communication error occurred.
This message is shown for example, if a modem to be used has no power supply.
31
The modem's supply voltage is too low.
32
The modem cannot be used due to SIM card error (modem message: "SIM Error")
33
The modem cannot be used as an incorrect PIN has been entered.
34
The modem cannot be used as an incorrect PUK has been entered.
35
Communication link to the network cannot be established or the communication link to the
network was lost, before the communication link to the remote site could be established.
36
Communication link to the GSM network was denied.
37
The APN parameters
38
Communication link to APN
39
The port for server connection is not defined.
40
The target name or port is not defined.
41
The other party has disconnected.
42
The communication link to the network was lost, after a communication link to the remote party
was already established.
70
Failed to establish communication link to the ElServer.
Possible cause: i.e. blocked by Elserver firewall.
71
The ElServer did not respond (timeout)
Possible causes: The EIServer machine is switched off or the ElServer has not been started.
72
The ElServer reports "unknown device type".
73
The EK280 does not understand the ElServer response.
Possible cause: i.e. transfer error
74
Sending error: When attempting to send data to the ElServer, the modem reported an error.
14
APN = "Access Point Name"
Application Manual
14
required to establish a GPRS communication link are missing.
14
was denied.
62
Advertisement
Table of Contents
