Fe260 With Integrated Analog Modem (Pstn Modem) - Honeywell Elster EK280 Applications Manual

Hide thumbs Also See for Elster EK280:
Table of Contents

Advertisement

EK280

6.3.3 FE260 with integrated analog modem (PSTN Modem)

Prerequisites for process described below:
The FE260 is connected and configured as described in chapter 6.3.1.
6.3.3.1 EK280 Parameterization
i
For parameterization of the EK280 you will require a connection cable for the optical interface as
well as the enSuite application, which can be downloaded for free at www.elster.com.
a) Connecting the time window
For the parameterization to work correctly, time windows 5 and 6 must be connected. To do this:
Connect a PC or laptop with enSuite installed to the EK280 optical interface using the connection
cable.
Start enSuite and set up the communication link to the EK280. (see chapter 3.1
communication link to the EK280 via optical interface
Select "Navigation" on the left-hand side and then
navigation window.
In the top of the device window open the path "Parameter" > "Interfaces" by clicking on the relevant
plus signs, and then select
In call windows 5 and 6 set start and end to the same value for each one and then select the
changes to
device" icon at the top of the enSuite window.
Then wait a minute, for any communications activity in progress on the EK280 to be safely stopped.
a) Send parameter file
Send the
"EK280_2v1.. - FE260 & i-modul Modem 144
chapter 3.6
"Send parameter
For the following customized settings and tests required, press "Navigation" on the left-hand side and
then
"Parameterize
i
All the values listed in enSuite under "Parameter" can be found on the "Serv." display tab of the
EK280 under the same path.
b) Setting time window for potential data queries
In the base configuration now displayed you can define time windows, during which data can be cyclically
retrieved from the EK280 via the modem. Time windows 5 and 6 are reserved for EK280 operation with an
FE260, and generally only time window 5 is used. Redundant time windows can be deactivated by setting
the time window start and end to the same value.
In the top of the device window open the path "Parameter" > "Interfaces" by clicking on the relevant
plus signs, and then select
For call window 5 set the start to "00:00" and the end to "23:59" and then select the
to
device" icon at the top of the enSuite window.
Wait for around a minute for the EK280 to detect the FE260.
Press the
"Transfer changes to
6.3.3.2 Retrieving data with enSuite
If the communication link to the EK280 is via the optical interface, press the "Disconnect" or the
"Disconnect from all
EK280 and then wait for the "o" on the EK280 display to stop flashing.
5
The * asterisk represents the lower-case letter, used to identify the file version, i.e. "a"
Application Manual
"Call time
windows".
file", page 10)
online" at the bottom of the navigation window.
"Call time
windows".
device" icon at the top of the enSuite window.
devices" icon to terminate the communication link between enSuite and the
", page 9)
"Parameterize
online" at the bottom of the
(Analogmodem)_*.WPP"
38
"Setting up the
"Transfer
5
to the EK280. (see
"Transfer changes

Advertisement

Table of Contents
loading

Table of Contents