Honeywell Elster EK280 Applications Manual page 48

EK280
Attach the JP2 jumper to the FE260 modem's PCB in the "program" position (jumper position:
see Figure 7 and Figure 9above).
Attach the serial data transmission cable to the "ST3" configuration interface on the modem's PCB
(see Figure 7 and Figure 9 above) and to the COM or USB port on the PC or laptop.
Set up the communication link between the PC or laptop and the modem as described in [4]
Modem Application – Operating
Parameterize the ComFTP according to your requirements as described in [4]
Application – Operating
Set up the communication link between the PC or laptop and the modem again.
Attach the JP2 jumper to the FE260 modem's PCB in the "operation" position.
6.3.6.5 EK280 data transfer activation
Set up a communication link via the optical interface between enSuite and the EK280 (see chapter 3.1
"Setting up the communication link to the EK280 via optical interface
Select "Navigation" on the left-hand side and then
navigation window.
In the top of the device window open the path "Parameter" > "Interfaces" by clicking on the relevant
plus signs, and then select
For call window 5 set the start to "00:00" and the end to "23:59" and then select the
to device" icon at the top of the enSuite window.
Wait for around a minute for the EK280 to detect the FE260.
6.3.6.6 Checking GSM field strength
Move the cursor to the "Serv." tab in the EK280's display, then to
Interfaces > Terminal interface > Hardware-Config. > MdxS2
Press the ENTER
Press the ENTER
Move the cursor to the "Serv." tab in the EK280's display, then to
Interfaces > Terminal interface > GSM and GPRS > GSM.L
Wait a few seconds until the field strength percentage is displayed under GSM.L.
i
With a field strength below 50% data transfer issues may be encountered. Adjusting the antenna
position can improve field strength in most cases.
Move the cursor to the "Serv." tab in the EK280's display, then again to
Interfaces > Terminal interface > Hardware-Config. > MdxS2
Press the ENTER
Press the ENTER
6.3.6.7 Opening the customer lock
In order for ComFTP to read data from the EK280 and save it on the server, at least one EK280 lock must be
permanently open. For this purpose it is recommended to use the customer lock, as this contains the least
write permissions and therefore avoids the risk of unauthorized parameter updates.
Move the cursor to the "Serv." tab in the EK280's display, then to
Device settings > Access > St.CL
If "open" is displayed below
If "zu" is displayed under
the keypad, enter the single digit customer lock with the keypad.
The default customer lock setting is "0". After pressing
"open" is now displayed under St.CL.
Move the cursor further down to
If "0 minutes" is not displayed under AutCL, set the value after pressing the
keypad to "0" and save the input with the
Application Manual
Instructions".
Instructions".
"Call time windows".
key and using the keypad set the value
key to save the input.
key and using the keypad set the value
key to save the input.
(customer lock status).
St.CL the customer lock is already open.
St.CL , move the cursor over to
AutCL and make sure that
"Parameterize online" at the bottom of the
to "GSM
to "transparent".
Cod.C and after pressing the
ENTER to commit the change, check that
"0 minutes" is displayed here.
ENTER button.
"ComFTP
"ComFTP Modem
", page 9) again.
"Transfer changes
Wavecom".
ENTER
ENTER button on the
46
key on