Honeywell Elster EK280 Applications Manual page 47

Hide thumbs Also See for Elster EK280:
Table of Contents

Advertisement

EK280
6.3.6.4 ComFTP application parameterization in the FE260 modem
For ComFTP parameterization you will require a standard serial data transmission cable
i
connecting your PC or Laptop with the FE260 modem as well as the WinPADS-EK program,
which you can download for free at www.elster.com.
The serial data transmission cable needed to connect to the FE260 is a 9-pole connector with pins (also
called "male") and to connect to the PC or laptop either a COM port connection (normally a 9-pole socket
connector, also called "female") or a USB connection.
Make sure that the mains voltage supply used to power the FE260 has been safely shut down and
then open the FE260 housing.
Danger!
Ensure the mains voltage is disconnected before opening the FE260 housing, ensure it
is not turned back on and verify that there is no voltage.
"ST3" configuration interface
with cable attached
"ST3" configuration interface
Figure 10: Configuration connector and "JP2" (mode) jumper for modem
Application Manual
Figure 9: FE260 with attached configuration cable
"JP2" (mode) jumper
"JP2" (mode) jumper
45

Advertisement

Table of Contents
loading

Table of Contents