Safety Information - McConnel ROBOCUT RC28 Operator's Manual

SAFETY INFORMATION

This machine has the potential to be extremely dangerous - in the wrong hands it can kill
or maim; It is therefore imperative that both owner and operator of the machine reads the
following section to ensure they are fully aware of the dangers that do, or may exist, and
fully understand their responsibilities surrounding use and operation of this machinery.
The operator of this machine is responsible not only for their own safety but equally for the
safety of all others who may come into the close proximity of the machine, as the owner
you are responsible for both.
When the machine is not in use it should be parked in a safe location on a firm level site
with power turned off.
In the event of any fault being detected with the machine's operation it must be stopped
immediately and not used again until the fault has been corrected by a qualified technician.
Before starting the machine the operator must read and understand all aspects of use
and maintenance of the machine as stated in this manual.
The machine must only be used by a responsible adult who is familiar with all aspects
relating to safe operation.
The machine must not be operated by children or non-authorised persons.
Operators must know the meaning of all operation and safety decals on both the
machine and the remote control unit.
Operators must know the procedure for switching the machine off normally and the
correct procedure for using the Emergency Stop.
Do not attempt to use the machine if the Emergency Stop switch is damaged or
malfunctioning.
Never use the machine with safety guarding removed or defective.
Operators should practice operation on flat open ground to familiarise themselves with
driving and manoeuvring the machine before attempting to use it on sloping ground.
Operators should practice manoeuvring the machine around obstacles, without the
rotors running, before using the machine for work purposes.
Never operate the machine if your vision is blocked or obscured by obstacles such as
vehicles, buildings, hedges, fences etc.; move to a safe position where you have a
clear, un-interrupted view of the entire machine.
5