Steering Bias Dial; Track Speed (Governor); Rotor Control Switch; Pair Button - McConnel ROBOCUT RC28 Operator's Manual

Steering Bias Dial

Control for setting steering angle bias when operating on sloped ground.
Left Steering Bias: Turn control dial to the left to select desired LH bias.
No Steering Bias: Place control dial into the central position.
Right Steering Bias: Turn control dial to the right to select desired RH bias.

Track Speed (Governor)

Sets maximum top speed limit.
Increase Maximum Speed Limit: Rotate control dial clockwise.
Decrease Maximum Speed Limit: Rotate control dial anti-clockwise.
NOTE: lower maximum speed settings will provide proportionally 'finer' speed control.

Rotor Control Switch

Rotor ON and OFF control.
Rotor ON : Place switch in 'UP' position to start the rotor.
Rotor OFF: Place switch in the DOWN position to 'STOP' rotor.
Pair Button & Screen 1◄►2 Swap
\
OPT
Press
Press

PRE-OPERATION CHECKS

switched off and the machine E-Stop activated (Power OFF).
The following checks should be made daily before using the machine;
 Check all safety guarding is in good condition and fitted correctly.
 Check nuts and bolts for tightness, retighten if required.
 Check oil and fuel levels, replenish if required.
 Check filters – clean or replace if required.
 Check rotors for damaged or missing blades, replace if required before use.
\
Button: Pair machine and remote control unit.
OPT Button: Toggles between screen 1 & screen 2.
All checks and inspections of the machine should be performed
with the machine parked on firm level ground with the engine
14