Maintenance; Engine Oil; Oil Capacity & Type; Engine Oil Level - McConnel ROBOCUT RC28 Operator's Manual

MAINTENANCE

Checks, maintenance and service tasks must only be performed with the machine parked on a
firm level site.
Never attempt to work on any machine that it not safely supported and chocked. Only use
suitable equipment for the task that is fully capable of supporting the machines entire weight.
Never attempt to work under a machine that is suspended on lifting equipment; the machine
must be in a fixed position and safely supported from below at all times.
Machine must be switched off and the remote control starter key removed before attempting to
inspect or work on any components under the machine.
Maintenance Stand
A purpose-made maintenance stand is available for
the RC28 that allows safe and easy access to the
base of the machine for service and maintenance
duties. Contact McConnel for further details.

ENGINE OIL

Oil Capacity & Type
6.0 litres (10.56 pints) 5w40 engine oil.

Engine Oil Level

Check engine oil level before each start-up and after every 8 hours of operation.
Oil level must be checked with the machine parked on level ground and the dipstick fully
inserted; level is correct when it is between the 'Min' and 'Max' marks on the dipstick.
If the level is below the 'Min' mark, oil must be added.
Do not overfill, the oil level must not exceed the 'Max' mark on dipstick.
Filler Cap
Dipstick
Oil Tank
28