Emergency Stopping (E-Stop)
When an E-Stop button is pressed (activated), all machine movements and functions will
cease immediately and the engine will be automatically switched off.
If an E-Stop button has been activated, that button must be reset before the machine can
be re-started.
Engine Speed (RPM)
The machine has 3 pre-set engine speed settings that are controlled using the + & -
buttons located on the left-hand side of the operator control unit, the speed settings are;
Idle speed: at this setting engine runs at low RPM – tracks and rotor will not operate.
Mid-speed: at this setting the engine runs at mid-range RPM - tracks can be operated.
Max-speed: at this setting engine runs at high RPM - tracks and rotor can be operated.
On initial start-up, the engine will run at the idle speed setting.
Selection of the required engine speed is by using + or - buttons.
For work the engine speed must be set at maximum RPM setting.
In emergency situations, the engine and all machine functions can be
immediately stopped by pressing an E-Stop button.
E-Stop buttons are located on the remote control unit and on the top
of the machine to the rear of the engine compartment.
16
+
-