Starting & Stopping The Engine; Machine And Remote Control Synchronisation; Starting The Engine; Stopping The Engine - McConnel ROBOCUT RC28 Operator's Manual

STARTING & STOPPING THE ENGINE
Before attempting to start the engine ensure you have read and understood the manual
and observed all safety instructions surrounding use of the engine and the machine.
Engine must only be started in open air, never in an enclosed
Before Starting
 Observe all safety instructions.
 Ensure machine is in the open air and not in an enclosed environment.
 Check fuel level; replenish if required.
Engine Starting Procedure

Machine and Remote Control Synchronisation

Check E-Stop buttons are in their de-activated (out) position; rotate E-Stop
buttons clockwise to release the stop, machine E-Stop must be illuminated.
Switch 'ON' the remote control unit by turning the power switch clockwise;
control unit will emit a series of 'buzzing' sounds and screen will display the
'unsynchronised' symbol.
Press GREEN button on right-hand side of remote control unit to pair the
remote unit with the machine.
When synchronised, the remote control unit screen
will display screen #1 information.

Starting the Engine

Engine Start: Hold engine switch in 'UP' position until the engine starts.
Release switch when engine starts; the switch will return to its central position.

Stopping the Engine

Engine STOP: Hold switch in 'DOWN' position until the engine stops.
Release switch when engine stops; the switch will return to its central position.
When the engine has stopped, activate machine E-Stop button to power-off the machine.
environment.
Remote Control Unit ON/OFF Switch
15
Unsynchronised Status
Synchronised Status