Safety Information - McConnel MAGNUM MULCHA 225 Operator's Manual

SAFETY INFORMATION

General safety rules:
▲ Always read and follow the instructions for the use and maintenance of the machine
before carrying out any work operations or servicing tasks.
▲ Improper use of the machine is both highly dangerous to persons and damaging to the
machine components – only use the machine for its designated task.
▲ Both operators and the maintenance fitters should be familiar with the machine and
fully aware of dangers surrounding improper use or incorrect repairs.
▲ Before starting, checks to both tractor and machine must be carried out as regards:
functionality, road safety, accident prevention rules.
▲ Even when using the machine correctly, stones or other objects may be thrown a long
distance. Therefore nobody must stand within the danger area. Special attention must
be paid when working near roads or buildings.
▲ Use tractor's fitted with safety cabs.
▲ The condition of flails and of machine guards must be checked before beginning the
daily work - they must be replaced if damaged or missing before you use the machine.
▲ During checks or repairs, make sure nobody could start the machine by mistake.
▲ Never carry passengers on the tractor.
▲ Never carry passengers on the machine.
▲ Never connect the power takeoff with the engine running.
▲ Never approach the machine until the rotor has completely stopped.
▲ Do not enter the working zone of the PTO shaft. It is dangerous to approach the
rotating parts of a machine.
▲ Keep the PTO shaft guard in good condition.
▲ Before starting, check the surrounding area for the likely presence of children and/or
animals.
▲ Do not stand near the machine when it is operating.
▲ Take care when working on rough or uneven terrain as lower protection is reduced.
▲ The PTO shaft must be assembled and disassembled only with the engine stopped
and the starting key removed.
▲ Before connecting the power takeoff, check that the speed and the rotational direction
correspond to those of the machine.
▲ Immediately replace missing or damaged safety decals.
▲ Before leaving the tractor with the machine attached, proceed as follows:
1. Disconnect the power takeoff,
2. Put the machine steadily on the ground using the tractor's hydraulic lift.
3. Apply the hand brake and, if the ground is steeply sloping, wedge the tractor.
4. Remove the starting key.
4