Inserting A Media Strip Into The Print Mechanics - CAB XD4M Operator's Manual

4 Loading Material
4.1.2

Inserting a Media Strip into the Print Mechanics

Fig. 9 Material feed path
1. Unroll a longer material strip of approx. 50 cm. Guide the media strip to the print mechanics as shown in figure 9.
2. XD4T only : Pull the detent pin (9). The pressing roller system (7) will swing upwards.
3. Turn lever (1) counterclockwise and lever (6) clockwise to lift both printheads.
4. Move guides (4,5) apart with the knob (3) until the media can pass between them.
5. Guide media strip through the print mechanics as shown in figure 10 to the upper print roller (2 / XD4M) respec-
tively to the pinch roller (8 / XD4T) and place the strip between the guides (4,5).
6. Move guides against the edges of the material by turning the knob (3).
7. Fix the media by closing the upper printhead.
8. XD4T only : Pull the detent pin (9). Push the pressing roller system (7) downwards and lock it with the detent pin.
9. Turn the media roll against the feed direction to tighten the media.
10. Close the lower printhead.
1
2
3
4
5
6
Fig. 10 Inserting a media strip into the print mechanics
XD4M
1
7
8
9
3
4
5
6
XD4T
13