Installation Instructions; Verify Hand And Bevel Of Door; Door & Frame Preparation - Cal-Royal CR9000 Installation And Programming Instructions

Stand-alone touchscreen access lock

Hide thumbs Also See for CR9000:

Installation and programming instructions (12 pages)

Table of Contents

Step #1 Verify Hand and Bevel of Door

Stand on outside/locked side of the door when determining the door hand.

Note:

This lock is non-handed and the lever can be flipped around to the desirable hand.

Left Hand

Hinges Left

Open Inward

"LH"

Step #2 Door & Frame Preparation

The accuracy of the door preparation is critical for the proper functioning

IMPORTANT:

and security of this lever handle lock. Misalignment can cause premature wear and tear

and a lessening of security.

For uncut Doors and Frames

A. Mark Centerline

Draw

horizontal

centerline for the lock body hole) on the edge and

on both sides of the door at the desired height

above the finished floor.

The recommended height from the floor to the

Note 1:

lock is 38"(97㎝).

If strike mortice already exist in frame, locate

Note 2:

the horizontal centerline of the lock using strike mortice

as reference.

Installation and Programming Instructions for Electronic Stand-Alone Cylindrical Locks