Advertisement
Quick Links
Installation manual for SDLP-RND-ADA
2
Item
No.
1
Trim Parts
2
3
Lock
4
5
6
7
Strike
8
9
10
Others
11
5
U P
LO C K
L
4
1
Description
Face Fixing Trim with Spindle
M4 x 45 Slotted Head Screws
Barn Door Lock
ST3.5 x 50 Wood Screws
Lock Bracket
Dust Proof Strike
Spring
Sleeve
Washer
Screw
Button
DO NOT USE:
Spade Bit
(x1)
2
(x2)
M4x45(x2)
ST3.5x50(x2)
7
3
6
Jamb
Trim
Lock
MIN 1/2"
MAX 7/8"
Door
U P
LO C K
L
(x1)
(x1)
mm
(x1)
40mm
(x1)
(x1)
(x1)
8
10
11
9
wall
Strike
Ø2-1/8"
Ø1-1/8"
Ø1"
Ø1/8" Drill Bit
(x1)
45mm
(x1)
Advertisement
Related Manuals for Cal-Royal SDLP-RND-ADA
Summary of Contents for Cal-Royal SDLP-RND-ADA
- Page 1 Installation manual for SDLP-RND-ADA DO NOT USE: Ø2-1/8" Spade Bit Ø1-1/8" Ø1" Ø1/8" Drill Bit LO C K (x1) (x1) (x1) (x1) (x1) (x2) 40mm 45mm M4x45(x2) (x1) (x1) (x1) (x1) ST3.5x50(x2) LO C K Jamb Item Description Face Fixing Trim with Spindle...
- Page 2 Remove Barn Door. Use template to mark pilot hole. Trim Face Bore 2 -1 " 2 -1 3 /1 6 " 2 -3 " 1 " /8 " 2 -1 9 /6 4 " Jamb LOCK TRIM The bore hole on the Jamb side is o set 9/64"...
- Page 3 1. Double check lock bore distance from 3/8" Step 1. Refer to template markings to ensure both lock and strike pilot holes are within door overlap requirements. Keep 3/8" safety margin to edges. DEPTH 3-1/2" Ø1" Do not drill too deep, you may damage the wall on the other side.
- Page 4 TIP: Before drilling, c over area around the bore hole with masking test bolt retraction; if not smooth, troubleshoot as follows: - Check Ø2-1/8" trim bore dimensions - Ensure hole is free of debris LO CK - Make sure 1" lock bore is perpendicular to trim bore - Check lock by removing it from bore and throwing the bolt.
- Page 5 Marking 1. Move the Barn Door to the Closed position; throw the lock bolt to mark the exact strike center position. Make sure this location is minimum 1-1/2" to the edge of the door. 1-1/2" 3/8" 2. Using the strike center position as a 25/32"...
- Page 6 ARROW SHOULD POINT UP LO CK LOCK LO CK L O C LO CK LO CK 1"...
- Page 7 When the width of the door is 35mm： When the width of the door is 45mm： When the width of the door is 40mm： 5. Push the button on top and use a 4. Install break-away screw and screw driver to push through center tighten with Allen wrench.