Cal-Royal CR9000 Installation And Programming Instructions page 22

Green and Red LED blinks.
✱
4. Press the button again.
Completes with beep sound.
Setting Up/Releasing Lockout Mode
I
Mstr
è
PIN
I
Touch screen with back of hand or fingers to activate.
1. Enter the Master PIN Code and press the
Green and Red LED blinks.
2. Enter the Program Code
Green and Red LED blinks.
3. Enter the Enable Code
Completes with beep sound.
Register RF Card
I
Mstr
è
PIN
I
Touch screen with back of hand or fingers to activate.
1. Enter the Master PIN Code and press the
Green and Red LED blinks.
2. Enter the Program Code
Green and Red LED blinks.
3. Enter the new RF Card Register Number(1~50) and press the
Green and Red LED blinks.
4. Place a RF Card about 2 seconds in front of the touchscreen (hear beep melody and
Green LED blinks.) and press the
Beep melody and Number pad blink one time.
F [Repeat step 3 and 4 for each new RF Card Register (if necessary)].
✱
5. Press the button.
Completes with beep sound.
[For example, you wish to register two RF Cards for User 11 and User 12 respectively.
I
Mstr
è
Press: PIN
touchscren (hear beep melody and Number pad blink one time)
Installation and Programming Instructions for Electronic Stand-Alone Cylindrical Locks
# 7 # 1
è è
Enable
3
è
Disable
7
and press the
1
or Disable Code
Enter the Card
# 8 #
è è
Register No. (1~50)
8
and press the
#
button.
# 8 # 1 1
è è
- 21 -
✱
✱
#
button.
#
button.
3 ✱
and press the
Place the Card in
#
è
front of the Touchpad
#
button.
#
button.
#
#
èplace the first card in front of the
button.
# ✱
è
button.
#
and then within 20