Page 1
Installation manual for SDLP-SQ-ADA DO NOT USE: Ø2-1/8" Spade Bit Ø1-1/8" Ø1" Ø1/8" Drill Bit L O C K (x1) (x1) (x1) (x1) (x1) (x2) 40mm 45mm M4x45(x2) (x1) (x1) (x1) (x1) ST3.5x50(x2) L O C K Jamb Item Description...
Page 2
Remove Barn Door. Use template to mark pilot hole. Trim Face Bore 2 -1 " 2 -1 3 /1 6 " 2 -3 " 1 " /8 " 2 -1 9 /6 4 " Jamb LOCK TRIM The bore hole on the Jamb side is o set 9/64"...
Page 3
1. Double check lock bore distance from 3/8" Step 1. Refer to template markings to ensure both lock and strike pilot holes are within door overlap requirements. Keep 3/8" safety margin to edges. DEPTH 3-1/2" Ø1" Do not drill too deep, you may damage the wall on the other side.
Page 4
TIP: Before drilling, c over area around the bore hole with masking test bolt retraction; if not smooth, troubleshoot as follows: - Check Ø2-1/8" trim bore dimensions - Ensure hole is free of debris LO CK - Make sure 1" lock bore is perpendicular to trim bore - Check lock by removing it from bore and throwing the bolt.
Page 5
Marking 1. Move the Barn Door to the Closed position; throw the lock bolt to mark the exact strike center position. Make sure this location is minimum 1-1/2" to the edge of the door. 1-1/2" 3/8" 2. Using the strike center position as a 25/32"...
Page 6
ARROW SHOULD POINT UP LO CK LOCK LO CK L O C LO CK 1"...
Page 7
When the width of the door is 35mm: When the width of the door is 45mm: When the width of the door is 40mm: 5. Push the button on top and use a 4. Install break-away screw and screw driver to push through center tighten with Allen wrench.