Cal-Royal CR9000 Installation And Programming Instructions page 11

1. Install latch in door. Be sure that bevel edge of bolt faces strike. Attach with two
screws supplied.
2. Install strike on the door frame.
3. Insert outside assembly through door, making sure that the lock body frame hooks
latch case and retractor engages bolt tail(s). DO NOT FORCE (See Detail A above). If
lock body does not engage latch easily, check door preparation for errors.
3a. Guide motor cable through 2-1/8"(54㎜) diameter hole.
3b. Guide touchpad cable through 2-1/8"(54㎜) diameter hole.
4. Guide motor cable and touchpad cable through hole on mounting plate.(See above
figure.)
5. Slide mounting plate over outside assembly, lining up upper and lower screw guides in
holes on outside assembly. Secure both assemblies with (2)10-32×1-13/32" (36㎜)
mounting plate screws. Do not over-tighten.
6. Attach motor cable connector to the motor cable header.
7. Attach the battery cable connector to the battery cable header.
8. Slide inside escutcheon over mounting plate.
CAUTION :
Fold cables and lay against the back recessed area of the inside escutcheon. Position
and bend wires to prevent binding when installing the inside escutcheon over the
mounting plate.
9. Install and secure inside escutcheon with the (2) M4×P0.7-15/32"(12㎜) screws through
inside escutcheon and into the mounting plate assembly.
10. Slide inside lever onto spindle and push in to attach.
11. Install (4) AA alkaline batteries into controller compartment being careful to align +/-
polarity properly.
12. Install battery cover and tighten screw.
Installation and Programming Instructions for Electronic Stand-Alone Cylindrical Locks
PROCEDURES
- 10 -