Cal-Royal NM Series Instructions

HOW TO CHANGE HANDING HOW TO CHANGE HANDING
If it is necessary to change handing, the instruction is as follows. If it is necessary to change handing, the instruction is as follows.
1.
1. Use Hex Key to unfasten the screw in the hole behind latch bolt (green label). Use Hex Key to unfasten the screw in the hole behind latch bolt (green label).
2.
2. Pull latchbolt out until it is entirely away from lock case. Pull latchbolt out until it is entirely away from lock case.
3. Rotate latchbolt to adjust handing.(see page 3)
3. Rotate latchbolt to adjust handing.
4.
4. Fasten the screw tightly into the hole and glue with Threadlocker (Loctite 242). Fasten the screw tightly into the hole and glue with Threadlocker (Loctite 242).
5. Use screwdriver flat head that fit on locking piece (green label) Push to Front
5. Use blade to screwdriver to flip locking piece (green label) forward twice to Front Side.
Side.(See illustration on page 2)
6. Handing is completely reversed.
6.
Handing is completely reversed.
latchbolt latchbolt
hole(green label) hole(green label)
Hex key Hex key
locking piece locking piece
(green label) (green label)
Warning! Warning!
Please read the instruction on Please read the instruction on
the installation guide about the the installation guide about the
correct position of spring cage. correct position of spring cage.