Miscellaneous Information - Cal-Royal CR9000 Installation And Programming Instructions

1 2 #
seconds,
melody and Number pad blink one time)
Delete RF Card
I
è Mstr
PIN
I
Touch screen with back of hand or fingers to activate.
1. Enter the Master PIN Code and press the
Green and Red LED blinks.
2. Enter the Program Code
Green and Red LED blinks.
3. Enter the delete card number (registered number) and press the
Beep melody and Green LED blinks.
#
4. Press the button.
Beep melody and Number pad blink one time.
F [Repeat steps 3 and 4 for delete of another card number(if necessary)].
✱
5. Press the button.
Completes with beep sound.
[For example, you wish to delete two RF Cards for User 11 and User 12 respectively.
I
Mstr
è
Press: PIN
Returning the Lock to Factory Defaults
1. Open the battery cover using a screw driver and remove the batteries.
2. After 10 seconds reinsert the batteries.
I
3. Touch screen with back of hand or fingers to activate within 5 seconds.
4. Enter the [#] button 5 times and factory defaults Master Code [123456] [#] and 30 [#]
and press the 1 [✱] button.
# # # # # è
5. A little later, the number pad is turned off and reset is complete.
Note:
All registered Master and User PIN Code data, etc., will be deleted, and the lock
will reset to the factory default.
Installation and Programming Instructions for Electronic Stand-Alone Cylindrical Locks
èplace the second card in front of the touchscreen (hear beep
#
Enter the Card
# è 9 # è
Registered No. (1~50)
9
and press the
# 9 # 1 1 #
è è

MISCELLANEOUS INFORMATION

1 2 3 4 5 6 #
✱
è
]
# è # è
#
button.
#
button.
# 1 2 #
è è
è 3 0 # è 1 ✱
- 22 -
✱
#
button.
# ✱
è è
]