Installing The Msata Ssd; Msata Installation Instructions - Cisco IR1101 Hardware Installation Manual

Installing the IRM-1100 Expansion Module
Step 5
On the alarm connector, insert the exposed part of the wire into the connection. Make sure that you cannot see any wire
lead. Only wire with insulation should extend from the connector. See
page 63.
Figure 38: Alarm Connector Captive Screws
Step 6 Use a ratcheting torque flathead screwdriver to torque the power connector captive screws (above the installed wire leads)
to 2 in-lb (0.23 N-m).
Step 7
Connect the other end of the wires to the alarm source, and re-attach the alarm connector to the Expansion Module.

Installing the mSATA SSD

Mini-SATA, or mSATA, is a low-profile interface connector that enables more effective Serial ATA (SATA)
integration in small form-factor drives roughly the size of a business card, such as solid state disks (SSDs).
This section provides an overview of the mSATA SSD available for the Cisco IRM-1100 Expansion Module.

mSATA Installation Instructions

Note: Ensure that you are using proper static discharge techniques such as a wrist strap and static mat.
Caution: Ensure the device is powered down before performing any removal or installation of a module.
The mSATA SSD module plugs into the slot shown in
page 64.
IR1101 Industrial Integrated Services Router Hardware Installation Guide
Figure 38: Alarm Connector Captive Screws, on
Figure 39: Cisco IRM-1100-SPMI Front Panel, on
Installing the mSATA SSD
63