Mounting On A Wall, Table, Or Other Flat Surface - Cisco IR1101 Hardware Installation Manual

Installing the Router

Mounting on a Wall, Table, or Other Flat Surface

The Cisco IR1101 can be mounted in a vertical or horizontal orientation. It can be mounted to a wall or other
flat surface, and can also be mounted to a DIN rail.
Note
See the
Tip When choosing a location for wall-mounting the router, consider cable limitations and wall structure.
WARNING: Read the wall-mounting instructions carefully before beginning installation. Failure to use the
correct hardware or to follow the correct procedures could result in a hazardous situation to people and damage
to the system. Statement 378
WARNING: A minimum of 1 inch clearance is required on all sides of the product when mounting to allow
for proper air flow.
The wall mounting kit contains the following:
• Mounting brackets (x2)
• Mounting screws (x4)
To mount the router on a wall or other flat surface, follow these steps:
Step 1
Attach the mounting brackets to the bottom of the router. Refer to
30 for guidance.
Installing the Router, on page 27
IR1101 Industrial Integrated Services Router Hardware Installation Guide
Mounting on a Wall, Table, or Other Flat Surface
for limitations on mounting with the IRM-1100 attached.
Figure 13: Cisco IR1101 Mounting Bracket, on page
29