Pluggable Module; Digital I/O Connections - Cisco IR1101 Hardware Installation Manual

Installing the IRM-1100 Expansion Module
NOTE: In order to prevent excessive side to side movement of the unit it is advised to install DIN rail stop plates such
as Mouser part Numbers 653-PFP-M, 651-1201662 or 845-CA402. These stop plates can be installed on one or both
sides of the unit to limit excessive side to side movement that typically occurs in high vibration environments.
Step 4 If you are using this Device in a vehicle, attach the ring terminal to the chassis using one of the screws provided and the
green or green and yellow striped wire. Connect the other end of the wire to the vehicle ground.
What to do next
After you install and properly ground the Device, you can connect the power wiring, the LAN cables, and the
cables for administrative access as required for your installation.

Pluggable Module

The Pluggable Module provides the IRM-1100 with a number of different configuration options. The installation
of the Pluggable Module into the Expansion Module is the same as installing it into the IR1101. See that
section at

Digital I/O Connections

The wired Digital I/O connector is show as (1) in
Pluggable Module, on page
IR1101 Industrial Integrated Services Router Hardware Installation Guide
37.
Digital I/O Connector, on page
Pluggable Module
15.
61