Installing The Router - Cisco IR1101 Hardware Installation Manual

3
C H A P T E R

Installing the Router

This chapter describes the equipment and the procedures for successfully installing the Cisco IR1101 ISR.
There is a separate section for installing the IR1101 with an Expansion Module.
• Installing the Router, on page 27
Installing the Router
This chapter describes the equipment and the procedures for successfully installing the Cisco IR1101 ISR.
There is a separate section for installing the IR1101 with an Expansion Module here: Installing the Router,
on page 27
This section contains the following sections:
CAUTION: Do not install the router or power supplies next to a heat source of any kind, including heating
vents.
WARNING: Read the installation instructions before connecting the system to the power source. Statement
1004
WARNING: Only trained and qualified personnel should be allowed to install, replace, or service this
equipment. Statement 1030
WARNING: Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
WARNING: Do not locate the antenna near overhead power lines or other electric light or power circuits,
or where it can come into contact with such circuits. When installing the antenna, take extreme care not to
come into contact with such circuits, because they may cause serious injury or death. For proper installation
and grounding of the antenna, please refer to national and local codes (for example, U.S.:NFPA 70, National
Electrical Code, Article 810, Canada: Canadian Electrical Code, Section 54). Statement 1052
WARNING: No user-serviceable parts inside. Do not open. Statement 1073
WARNING: This product is not intended to be directly connected to the Cable Distribution System. Additional
regulatory compliance and legal requirements may apply for direct connection to the Cable Distribution
System. This product may connect to the Cable Distribution System ONLY through a device that is approved
for direct connection. Statement 1078
WARNING: A minimum of 1 inch clearance is required on all sides of the product when mounting in either
horizontal or vertical orientation. Stacking heat-dissipating objects on top of the router is not allowed. I/O
IR1101 Industrial Integrated Services Router Hardware Installation Guide
27