Cisco IR1101 Hardware Installation Manual page 46

Pluggable Module
Item
3
Step 5 Push in each SIM until it clicks into place. When the SIMs are installed, re-attach the access plate previously removed
with a screwdriver. Torque to 2.8 to 3.8 inch-lbs (0.9-1.1 newton meter).
Note: Ensure the cover is properly aligned with the screw hole.
Step 6
If your Pluggable Module is the type that has a USB port, make sure that the USB cover is properly installed. Place the
USB cover (1) with the plug indentation against the USB port (2). The half circle of the USB cover fits behind the latch
lock screw. See
Figure 23: USB Port Cover Installation
Step 7
Tighten the latch lock screw to a torque of 2.8 to 3.8 inch-lbs (0.3 to 0.4 newton meter). Refer to
Finished Installation, on page 41
IR1101 Industrial Integrated Services Router Hardware Installation Guide
40
Figure 23: USB Port Cover Installation, on page 40
for a finished USB cover installation.
Description
SIM 1 (away from device)
for details.
Installing the Router
Figure 24: USB Cover