Cisco IR1101 Hardware Installation Manual page 41

Installing the Router
Figure 18: Attaching the Bracket to the DIN Rail
Step 1 Position the router so that the lower edge and spring of the Din clip (1) engages with the bottom section of the Din rail
(2).
Step 2 Push up on the router so that the spring of DIN clip (1) compresses against the lower section of DIN rail (2) and then
rotate the router so that the top hook of the DIN clip (1) clamps to the top section of DIN rail (2).
Step 3 To remove the router from the DIN Rail, simply reverse the procedure.
What to do next
Note The procedure to attach the unit to the rail is the same with both orientations.
IR1101 Industrial Integrated Services Router Hardware Installation Guide
Attaching the Bracket onto the DIN Rail
35