8 Automatic Workpiece Measurement in JOG Mode (SINUMERIK 840 SW2)
8.4.7 Measuring a reference point on the workpiece
8.4.7
Measuring a reference point on the workpiece
Prog. Para.
Sett. Data
JOG
Program reset
Workpiece measurement: Measure reference point
Zt
M/W
Offset probe (pos. only)
Measure
The following parameters have to be set:
•
Offset of probe V (positive only)
•
Angle 1 to axis 1 (abscissa)
•
Angle 2 to axis 1
•
Infeed in the applicate (drilling axis) incrementally to overtravelling the workpiece.
When you press the softkey "MEASURE", a selection display appears requesting you to
position the probe at the reference point.
8–26
Data I/O
Program.
W2
W1
M1
P
M2
V
V
©
Siemens AG 1990 All Rights Reserved
08.96
Diagnostic
User
Mode grp.: 1
Channel : 1
V
R07=
30
W1 R06=
10
W2 R05=
120
Zt R19=
20
6FC5197- AB70
SINUMERIK 840/850/880 (BN)