L976 Calibrating The Workpiece Probe (M); L977/L979 Workpiece Measurement (M); L978 Workpiece Measurement (M); L981 Workpiece Measurement (T/M) - Siemens SINUMERIK 840 User Manual

2 Defining Parameters

2.7.4 L976 Calibrating the workpiece probe (M)

2.7.4 L976 Calibrating the workpiece probe (M)
R23 = 5 4 3 2 1
2.7.5

L977/L979 Workpiece measurement (M)

R23 = 1 Measure hole
2 Measure shaft
11 Measure slot
12 Measure web
21 ZO determination in the hole
22 ZO determination at the shaft
31 ZO determination in the slot
32 ZO determination at a web
2.7.6

L978 Workpiece measurement (M)

R23 = 0 1-point measurement (ZO determination at a surface)
1 1-point measurement
2 Multi-point measurement paraxial
3 Angle measurement
10 ZO determination at a surface
11 Measure surface
12 Multi-point measurement paraxial
13 Angle measurement
2.7.7 L981 Workpiece measurement (T, M)
R23= 1 Searching for a hole/slot on the end face
2 Searching for a hole/slot at the cylinder
_______
*) Function implemented with Version 3.2 and higher
2–8
0 With reference data in the plane (not in the case of
probes with ZD numbers)
1 With reference data in the applicate
2 With arbitrary data in the plane
3 With arbitrary data in the applicate
0 Bore
2 Surface
not in the case of 1-point measurement
3 SLOT
0 No calculation of probe ball
1 Calculation of probe ball
0 4 axis directions with NC type 2
1 1 axis direction; state measuring axis and axis direction
2 2 axis directions; state measuring axis
0 No position determination
1 Position determination
with differential measurement
with differential measurement
with differential measurement
with differential measurement
©
Siemens AG 1990 All Rights Reserved
08.96
*)
*)
*)
*)
6FC5197- AB70
SINUMERIK 840/850/880 (BN)