Workpiece Probe In The Toa Memory For Turning Machines - Siemens SINUMERIK 840 User Manual

1 Introduction

1.4.2 Workpiece probe in the TOA memory for turning machines

1.4.2 Workpiece probe in the TOA memory for turning machines
On turning machines, measuring cycles are classified in the following types according to their
respective locations:
Dn Type 5
P0 P0 P0 Tool number
P1 5 Tool type
P2 L1 L1 Geometry
P3 L2 L2 Geometry
P4 r Diameter/radius
P5 0 L1 Wear
P6 0 L2 Wear
P7 0 Diameter/radius
P8 0 Base (add. TO)
P9 0 Base (add. TO)
Fig. 1.9 Workpiece probe type 5 in the TOA memory for turning machines
Dn Type 6 (8)
P0 P0 P0 Tool number
P1 6 Tool type
P2 L1 L1 Geometry
P3 L2 L2 Geometry
P4 r Diameter/radius
P5 0 L1 Wear
P6 0 L2 Wear
P7 0 Diameter/radius
P8 0 Base (add. TO)
P9 0 Base (add. TO)
Fig. 1.10 Workpiece probe type 6 (8) in the TOA memory for turning machines
(type in parentheses = in front of turning centre)
1–10
F
L2
L2
r
©
Siemens AG 1990 All Rights Reserved
SINUMERIK 840/850/880 (BN)
08.96
L1
r
L1
F
6FC5197- AB70