Measuring A Hole - Siemens SINUMERIK 840 User Manual

08.96
8.4.1

Measuring a hole

Prog. Para. Sett. Data
JOG
Program reset
Workpiece measurement: Measure hole
S
W
SETPOINT DIAMETER
Measure
The only parameter that has to be set is the setpoint diameter of the hole. When you press the
softkey "MEASURE", a selection display appears requesting you to position the probe at the
centre of the hole.
©
Siemens AG 1990 All Rights Reserved
SINUMERIK 840/850/880 (BN)
8 Automatic Workpiece Measurement in JOG Mode (SINUMERIK 840 SW2)
Data I/O Program.
D
6FC5197- AB70
8.4.1 Measuring a hole
Diagnostic User
Mode grp.: 1
Channel : 1
D R42= 40
8–9