Step 2 Setting The Hardware; Parts Of The Board And Factory Defaults - Contec DIO-0808L-PCI User Manual

Step 2 Setting the Hardware

This section describes how to set the board and plug it on your PC.
The board has some switches and jumper to be preset.
Check the on-board switches and jumpers before plugging the board into an expansion slot.
The board can be set up even with the factory defaults untouched. You can change board settings later.

Parts of the Board and Factory Defaults

Figure 2.1. shows the names of major parts on the board.
Note that the switch setting shown below is the factory default.
DIO-0808L-PCI
- Interface connector
(CN1)
37 19
36 18
21 2
20 1
Figure 2.1. Component Locations
DIO-0808L-PCI
SW1
- Board ID setting switch
BOARD ID
SW1
BOARD ID
8
2. Setup
13