Digital i/o board with opto-isolation for pci, digital input board with opto-isolation for pci, digital output board with opto-isolation for pci (71 pages)
Page 2
Chapter 1: General Description This document contains the specifications pertinent to the wireless LAN module (FX-DS540-MPCI4W), which comply with IEEE802.11a, IEEE802.11b and IEEE802.11g. FX-DS540-MPCI4W is used attaching in the wireless LAN access point. Features 2.4GHz Wireless LAN module ・ IEEE802.11b and IEEE802.11g compatible ・...
Page 3
Chapter 2: Characteristics Table1 : Mechanical Characteristics Dimensions 39.65 x 59.6 x 2.4 (mm) Weight 12g (max.) 59.6 39.65 (mm) Figure1 : FX-DS540-MPCI4W Table2 : Electrical Characteristics Supply voltage Vcc Nomial : 3.3V Extreme : 3.3V +/- 0.3V Strage temperature -25 to 70 deg.C Humidity 20 to 95%...
Page 4
Chapter 3: Setup FX-DS540-MPCI4W is used attaching in the wireless LAN access point. The wireless LAN access point is restricted only to CONTEC products. As an example, the case where it attaches in FX-DS540-ADPL-NR52-U is introduced. Figure2 : How to attach in FX-DS540-APDL-NR5 Attach a coaxial cable and fix.
Page 5
Chapter 4: Notes When FX-DS540-MPCI4W is installed in the wireless LAN access point, the following remarks are to be considered: FX-DS540-MPCI4W is designated its own FCC ID Number: PQRDS540-MPCI4WAP; therefore, the FCC ID Number should be appeared on the label on the exterior of the wireless LAN access point unless it is visible from outside.
Need help?
Do you have a question about the DS540-MPCI4WAP and is the answer not in the manual?
Questions and answers