Step 2 Setting The Hardware; Parts Of The Board And Factory Defaults - Contec DIO-32DM2-PE User Manual

Step 2 Setting the Hardware

This section describes how to set the board and plug it on your PC.
The board has some switches to be preset.
Check the on-board switches before plugging the board into an expansion slot.
The board can be set up even with the factory defaults untouched. You can change board settings later.

Parts of the Board and Factory Defaults

Figure 2.1. shows the names of major parts on the board.
Note that the switch setting shown below is the factory default.
- Pull-up voltage setting
switches (SW1- SW5)
Figure 2.1. Component Locations
DIO-32DM2-PE
DIO-32DM2-PE
JP1
JP2
JP3
- Interface connector (CN1)
- SC Connector (CN2 CN3)
（CN2) （CN3)
SW6
CN3
CN2
BOARD ID
- Pull-up voltage setting
pins (JP1 -JP3)
JP1
1 2 3
JP2
1 2 3
JP3
1 2 3
2. Setup
- Board ID setting swith
SW6
BOARD ID
8
13