External Connection; Using The On-Board Connectors; Connecting A Device To A Connector - Contec DIO-0808L-PCI User Manual

3. External Connection

This chapter describes the interface connectors on the board and the external I/O circuits.
Check the information available here when connecting an external device.

Using the On-board Connectors

Connecting a Device to a Connector

To connect an external device to this board, plug the cable from the device into the interface connector
shown below.
Interface connector (CN1)
Figure 3.1. Interface Connector and Applicable Cable Connector
DIO-0808L-PCI
- Connector used
37 19
37-pin D-SUB, female connector
36 18
DCLC-J37SAF-20L9(mfd. by JAE)
Thumb screw : UNC#4-40(inch screw)
- Applicable connectors
17JE-23370-02(D8C) (mfd. by DDK, Male)
21 2
FDCD-37P (mfd. by HIROSE, Male)
20 1
DC-37P-N (mfd. by JAE, Male)
CN1
3. External Connection
27