Spot View - Vitek TRANSCENDENT VT-TR5HA Series Manual

Live Preview Introduction
Add Scheme
Ø
Click in area 1 to create a new scheme. Click
to delete it.
Configure Scheme
Ø
a) Select a scheme in area 1 and then click the screen mode button on the tool bar to set the
screen mode of the scheme.
b) Select a camera window in area 2 and then double click the camera in area 3. The camera
will be added into the selected window. One camera in the same scheme cannot repeat. You
can right-click menu "Clear" in area 4 to remove a single camera or click
the cameras.
c) Click "Apply" to save the settings.
Start Sequence View
Ø
Go to live preview interface and then click
window and then click
interface to pause the view; double click again to restore the view. Click
view.
5.2.4

Spot View

Click StartàSettingsàSystemàBasicàOutput SettingsàOutput 2 to go to the interface as
shown below.
Click on the left to create a new scheme. Each scheme can only add one analog camera.
Select a scheme on the left and then double click or drag a camera on the right to the scheme
window in the middle of the interface. After finishing the settings of all the schemes, select the
to start scheme view in sequence. Double click the sequence view
on the top right corner of the scheme
to pop up a window. Set the dwell time in the
30
DVR User Manual
to remove all
to stop the